You know there is a stove in every house. Stoves have different types in terms of being built-in or comedic, steel or glazed body and different number of flames. In this article, an issue of glazed stoves is examined, and that is the disappearance of the glaze of these stoves. This is important because without this glaze it will be both difficult to clean the stove and if you do not prevent the progress of this case, your stove will go to ruin.
Eliminate rust or burn paint
1. Cleaning the surface: In this method, you must first thoroughly clean the damaged area. For this case, depending on the amount of dirt in the place, you can use substances such as vinegar, baking soda and ammonia. After spraying the material on the surface and giving the necessary time for the necessary interactions between the dirt and your cleaning material, use a soft scotch or a clean cloth to clean the desired surface.
2. Shaving the damaged part: The next thing you need to do is to use the tools such as a spatula or special razors to do the desired hardening in that part and remove all burns or rust. Be careful not to damage the healthy parts of the glaze. To prevent this, it is better to first determine the desired range using the corner of the spatula and then rough the surface.
3. Sanding: The next thing you need to do to clean your stove is sanding. By sanding in addition to creating a one-handed surface, you can be sure that you have removed all the corrosion or rust or burns of the glaze. To do this, first prepare a sandpaper of 100 degrees or higher and sand the desired surface in all directions and in turn. Try to keep as much balance as possible between sanding in different directions to have a completely one-handed surface. This, if done properly, will prevent re-rusting.
4. Cleaning the surface: After sanding, it is important to thoroughly clean the surface once. Because by sanding, small particles are separated and these particles can cause the surface not to stain. You can also use materials such as thinner to do this. Using this material and a soft, lint-free cloth, thoroughly clean the entire surface so that no chips are left on the surface.
5. Painting: The last and to some extent the most important stage is painting. First, make sure that you use a special paint to do this so that it does not burn in the heat. After preparing a special paint (which is better to be in the form of spray), paint the desired surface. First, cover the healthy areas with glue, cardboard or plastic. Then apply the spray evenly on the surface with one hand. Try to adjust the amount of spray so that the paint does not spill. Also make sure that your hand is at a constant distance from the surface and on the other hand avoid spraying as a separate point. The best way to spray paint is to go back and forth at a constant speed.
Finally, it should be noted that if you do not have the skills of an infidel in painting, it is better to leave it to someone with enough skills and expertise to do it well and prevent future injuries.